After successful installation of Astrill applet, you will be able to see the confirmation message(as mentioned within the screenshot below) Then copy the command from member-zone > VPN SERVICE > Router Set-up as shown in screenshot below.ħ. After successful login, you will see that the command line path will change to root.Ĥ. Hence, after entering the password simply press 'Enter' key.ģ. Please note that while inputting the password, you will not be able to see any asterisks/stars or any characters. The username that should be used is 'root'. Once you will be able to see the login option, kindly input the login credentials To Telnet into Router, kindly open Command Prompt and enter the following command 'Telnet Your Router's IP address', for e.g. You can check the following articles for reference.įor Windows, you might need to enable the Telnet(Windows built-in Client):ġ. It is also possible to install Astrill applet on DD-WRT flashed routers using command line as well. You will see the following screen:Ĭhoose a server from the drop down box and hit Connect. If everything went correctly, you will see the following screen:Īstrill is now installed on tab Status->My Page, so let’s go there. Then hit “Run Commands” and wait a few moments. In the Commands box type your Astrill VPN Applet installation command: You will see a screen similar to this one: If you are prompted for a password, the default is admin/admin (unless you have changed it). To install Astrill VPN Applet on your router, first navigate to the router web control panel using your browser, e.g. Login into your account from Astrill website and go to VPN SERVICE > Router Set-up & copy Installation Command.Įxecute Astrill VPN Applet Installation Command Install Astrill VPN Applet From Router's Web Interface Copy Astrill VPN Applet Installation Commandd 1.2 Execute Astrill VPN Applet Installation Command.
1.1 Copy Astrill VPN Applet Installation Commandd.1 Install Astrill VPN Applet From Router's Web Interface.
0 kommentar(er)
